Water stains spreading on the ceiling
We trace the stain back to the entry point with a moisture meter, repair the underlayment or flashing, reset the tile, and water-test the repair before we leave.
Tile Roof Leak Repair in Florida starts with finding the actual source, not guessing. We handle cracked tiles, failed underlayment, flashing, and pipe boot leaks on Spanish tile, concrete tile, and clay tile roofs across the state. Our licensed crews work to Florida Building Code and Miami-Dade NOA standards, and we test every repair before we leave. Call (833) 356-1017.

Tile Roof Leak Repair in Florida is the process of finding and sealing the point where water enters a tile roof assembly, then restoring the layers underneath so the roof sheds water again. On a tile roof, the tile itself is a rain screen, not the waterproof layer. Water gets in through cracked or slipped tiles, failed flashing, a split pipe boot, or deteriorated underlayment. We pull the affected tiles, inspect the underlayment, replace what has failed, and reset the tile so the roof looks untouched from the street.
Florida roofs take a beating. Afternoon thunderstorms dump two inches of rain in an hour, summer attic temperatures push past 140 degrees, and salt air along the coast eats fasteners and flashing. That is why tile roof repair Florida homeowners call us for is rarely just one broken tile. We see flashing failure at valleys and sidewalls, pipe boot leak after pipe boot leak, and underlayment failure on roofs that are 15 to 20 years old. If you have water stains on the ceiling, call (833) 356-1017.
Every repair starts with a full inspection and ends with a water test. We tell you upfront what is covered in the price and what would be a separate job, so there are no surprises on the invoice.
Roof walk with ladder and safety harness, attic check with moisture meter and inspection camera, and a written report identifying the leak source. Photos included so you can see what we found.
We lift the affected tile with a pry bar and roofing hammer, complete the repair underneath, and reset the original tile. Broken tile is replaced with matching stock where available.
Failed roofing underlayment is cut out and replaced with code-compliant material. Flashing at valleys, sidewalls, and penetrations is renewed and sealed with Geocel or Henry roof sealant.
Split or UV-damaged pipe boots are replaced with new EPDM collars and sealed. This is one of the most common sources of tile roof leaks we find on Florida homes.
We run water over the repair area and watch it from the attic before we pack up. Then we magnet-sweep the yard, haul off old material, and send you the warranty paperwork.
You call (833) 356-1017 or book online. We ask what you are seeing, water stains, dripping, or a ceiling bulge, and schedule an inspection. Emergency calls get same-day dispatch. Most non-emergency inspections happen within 24 to 48 hours.
A licensed inspector walks the roof with a ladder and safety harness and checks the attic with a moisture meter and inspection camera. We photograph cracked tiles, rusted flashing, and wet decking. You get a written report with the leak source and the repair options.
You get a line-item scope: how many tiles come up, what underlayment gets replaced, which flashing and pipe boots are renewed. Price is fixed before work starts. No surprise add-ons halfway through the job.
The crew lifts the tile with a pry bar and roofing hammer, replaces failed underlayment, flashing, or pipe boots, and seals penetrations with roof cement and flashing tape. Then we run a water test over the repair area and watch it from the attic. Takes two to four hours on a typical job.
We magnet-sweep the yard for nails, haul off old material, and send you photos of the completed repair plus your warranty paperwork. If anything weeps in the next rain, call us and we come back at no charge.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Used in the attic to trace water back to its entry point and confirm the decking is dry after the repair.
Lifts tile without cracking it and resets it tight so the roof line stays clean and the repair disappears.
Fastens new underlayment and flashing quickly and to code, with consistent depth so nothing tears through the material.
Applies Geocel, DAP, and Henry roof sealant evenly at flashing laps, pipe boots, and penetrations.
Gets our inspectors and crews onto steep-slope tile safely, meeting OSHA safety certification requirements.
Emergency roof tarping after a storm to stop water intrusion until the permanent repair is completed.
A Tampa homeowner had a spreading ceiling stain and two quotes for a full roof replacement. The actual leak was a split pipe boot and a two-foot section of failed underlayment, hidden under sound tile.
We replaced the pipe boot, cut out and replaced the failed underlayment, and reset the original tile. The repair took three hours and cost under $600. The ceiling stayed dry through the next two storm systems.
A Cape Canaveral home lost a dozen tiles and the valley flashing lifted during a hurricane band. Water was running down the inside of the garage wall every time it rained.
We tarped the roof the same night, then returned to replace the broken tile, renew the valley flashing, and replace the underlayment under it. Water test passed on the first try. No leaks through the following season.
A Saint Cloud home had leaks in three separate spots on a 19-year-old Spanish tile roof. The homeowner was told the whole roof had to come off.
We lifted tile across the two worst sections, replaced the failed underlayment and flashing, and reset the original tile. The repair cost about a third of a replacement and has held for two rainy seasons.
Most tile roof leaks trace back to one of a handful of failures. Here is what we see most often and how we fix it.
Ask a pro →We trace the stain back to the entry point with a moisture meter, repair the underlayment or flashing, reset the tile, and water-test the repair before we leave.
We replace the boot with a new EPDM collar, seal it with Geocel, and check the surrounding tile and underlayment for hidden damage at the same time.
We renew the flashing with code-correct metal, seal the laps with flashing tape and roof cement, and reset the tile so the repair blends into the roof line.
We lift the tile in the affected area, replace the failed underlayment with code-compliant material, renew the flashing, and reset the tile. Full replacement is only recommended when failure is roof-wide.
Most tile roof leak repairs in Florida run $350 to $1,800 in 2026. A single cracked tile or pipe boot reseal sits at the low end. A repair that requires lifting a field of tile and replacing underlayment and flashing runs higher. Access, roof pitch, tile type, and how far water has traveled all move the number. You get a fixed written price before we start.
The four most common causes we find are failed underlayment, flashing failure at valleys and sidewalls, split pipe boots, and cracked or slipped tiles. Florida heat cooks underlayment until it turns brittle, and salt air rusts fasteners and flashing. After a hurricane or a strong thunderstorm, wind-driven rain pushes into spots that stayed dry for years. We inspect all four on every call.
Yes, most tile roof leaks can be repaired without replacing the roof. If the tile is sound and the leak is isolated to underlayment, flashing, or a pipe boot, we fix those layers and reset the original tile. Full replacement only makes sense when underlayment has failed across the whole roof, usually past 20 years. We tell you which one you are looking at.
A typical repair takes two to four hours on site. Small fixes, a pipe boot or a few cracked tiles, can be done in under two hours. Larger jobs that involve lifting a section of tile and replacing underlayment may run a full day. We water-test the repair before we leave, so you know it is dry when we pack up.
We run tile roof repair crews across the state, from the coast to inland lake country. Wherever you are in Florida, a licensed inspector can be on your roof, with a written price before any work starts.
Water stains spread fast, and a small leak becomes rotted decking and a bigger bill. Call (833) 356-1017 and we will get a licensed inspector on your roof, with a fixed written price before any work starts.
Schedule Inspection (833) 356-1017 →Call us at (833) 356-1017 any time, day or night. We answer live, and for active leaks we dispatch the nearest crew immediately. You can also email [email protected] with photos of the damage and we will respond the same business day. We serve the entire state of Florida.